Interior drain tile, sump basins, and vapor barrier wall systems installed by technicians who've done this hundreds of times in Aurora, MN basements.
Basement waterproofing mistakes usually come down to one thing: fixing the symptom instead of the source. A contractor who paints over a wet wall without checking cove joint condition or exterior grading is setting you up for the same call again in a year or two.
Every technician carries full state licensing and liability coverage before they ever step into your basement.
Our Aurora, MN crews are staffed locally, so a wet basement call doesn't sit in a national queue for a week.
You get one written number before drilling starts, covering drain tile, sump basin, and discharge line.
Thermal imaging helps us confirm whether a stain is active moisture or an old, already-fixed leak.
Every Aurora, MN Basement Waterproofing job starts with an inspection, not a generic package — here's what that typically includes.
We route drain tile beneath the existing slab line so flooring disruption stays minimal during installation.
Battery backup is available for any sump system, so a power outage during a storm doesn't undo the whole fix.
The cove joint where the floor meets the foundation wall is one of the most common Aurora, MN leak points, and we seal it as part of every interior system.
We install membrane on masonry walls before any insulation or framing goes up, so moisture never gets a chance to reach finished materials.
Window wells that hold water after a storm are a direct pressure point against the glass and frame — we add gravel beds and drain lines tied into the main system.
A quick phone conversation lets us bring the right equipment on the first visit instead of a second trip.
A technician walks the basement with a moisture meter, checking walls, floor, and cove joints to trace the water back to its actual source.
You'll see drain tile footage, sump specs, and labor broken out separately, not one vague lump-sum number.
You'll get warranty paperwork and a walkthrough of how the system works so you know what to expect going forward.
"Our finished basement started smelling musty and we finally found a wet spot behind the drywall. They cut open the cove joint, ran drain tile, and it's been dry for over a year."
— Aurora Homeowner
"Water came in around our window well every time it rained hard. They regraded it and added a drain line — problem solved."
— Aurora Customer
"They walked us through exactly why the water was coming in before quoting anything, which no one else had bothered to do."
— Aurora Homeowner
"Installed a battery backup sump pump for us right before a big storm season — glad we did it when we did."
— Aurora Customer
Cost depends on linear footage, sump basin size, and whether cove joint sealing is included — we won't give a number without an in-person inspection.
Yes — interior drain tile requires cutting a channel along the slab edge, which we patch with concrete once the system is installed.
Most residential interior drain tile and sump installations finish in one to three days depending on basement size.
Not always — an isolated, non-leaking crack can sometimes be handled with injection alone.
Coverage depends on your policy and the cause of the water intrusion — we can document conditions for a claim, but approval is up to your insurer.
Warranty terms are often transferable if you sell the property later.
We install interior drain tile and sump systems throughout Aurora and the surrounding Aurora, MN service area, including the zip codes listed below.
Zip codes we serve in Aurora, MN: 55705
Call now for a free inspection and a flat-rate quote before anything gets worse.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
